How to use this calculator
- Enter your target mash temperature — 65–67 °C suits most ales.
- Measure your grain temperature and enter it; cold grain needs hotter strike water.
- Enter the grain weight and your chosen water-to-grain ratio (2.5–3.5 L/kg is typical).
- Heat the calculated volume of water to the strike temperature, preheat your mash tun, then stir the grain in.
What the inputs mean
Target mash temperature is the rest temperature you want the mash to settle at after the grain goes in. Grain temperature is how warm the crushed malt actually is — room temperature in summer, much colder in winter. Grain weight is the full grist bill. Water-to-grain ratiosets the mash thickness: a lower ratio (thicker mash) needs hotter strike water because less water carries heat into more grain.
Formula
John Palmer's infusion equation from How to Brew (§3), metric form:
Tw = Tm + (0.41 ÷ r) × (Tm − Tg)Tw is the strike water temperature, Tm the target mash temperature and Tg the grain temperature (all °C), and r the water-to-grain ratio in L/kg. The 0.41 is the specific heat of grain relative to water. The book's imperial form reads (0.2 ÷ r) with r in quarts per pound and temperatures in °F — the same physics, different unit baggage.
Example
A 5 kg grain bill at 20 °C, target mash 67 °C, ratio 2.7 L/kg: Tw = 67 + (0.41 ÷ 2.7) × (67 − 20) = 74.1 °C, and you need 13.5 L of water.
Accuracy & limitations
- The formula assumes a preheated mash tun. A cold tun steals 1–3 °C — preheat it or expect to land low.
- This is an estimate from an empirical heat-balance formula, not a measurement. Stir well and verify with a thermometer before starting the mash rest timer.
- Only valid for the first infusion (dough-in). Step mashes need the boiling-water infusion formula instead.
- Accepted ranges: target 60–75 °C, grain 0–40 °C, grain 1–50 kg, ratio 1.5–4 L/kg. Out-of-range values are rejected, not extrapolated.
FAQ
Is a thin or thick mash better?
Neither is universally better — it depends on your process. A thick mash (2–2.5 L/kg) uses less water, heats faster and suits single-infusion mashes with well-modified malts. A thin mash (3–4 L/kg) is easier to stir, forms fewer dough balls and suits step mashes and BIAB. Most homebrewers land in the middle, around 2.5–3.5 L/kg.
My grain comes straight from the fridge — what do I do?
Measure its temperature and enter it. The formula already accounts for cold grain: grain at 4 °C needs noticeably hotter strike water than grain at 20 °C. If you prefer, let the grain warm up toward room temperature first and enter the measured value.
Why does my mash always land a couple of degrees low?
The formula assumes a preheated mash tun. A cold tun steals 1–3 °C from your strike water, which is the most common reason for landing low. Preheat the tun with hot water, stir thoroughly after dough-in, and check the temperature in several spots — the top of the mash reads warmer than the bottom.
Can I use this for step mashing?
Only for the first infusion (dough-in). Later mash steps use the infusion formula — adding boiling water to raise an existing mash — which is a different calculation with different inputs.