How to use this calculator
- Enter the volume of finished, fermented wash you will charge to the still, and its ABV — measured with a hydrometer, or planned when you designed the wash with thesugar wash calculator.
- Note the pure alcohol in the wash: every fraction below is planned as a share of that figure.
- Set out a row of small, numbered jars (150–250 mL each) — enough to cover the total distillate shown — and swap jars as the running total passes the range boundaries.
- Discard the foreshots, the first range off the spout. Always. Never drink them.
- Let the jars air overnight, then nose and taste along the row and blend your hearts cut from the clean jars. The numbers get you close; your senses make the cut.
What the inputs mean
Wash volume is the fermented wash that goes into the still, headspace and all. If you built the wash with the sugar wash calculator, it is the total batch volume you made up there.
Wash ABV is the alcohol content of that wash. A sugar wash fermented to 1.000 typically lands near the lower of the two potential-ABV figures the sugar wash calculator shows; a wash stopped early or measured directly should use the hydrometer reading instead.
The model
Everything starts from the pure alcohol in the charge:
Pure alcohol A (L) = wash volume × ABV ÷ 100Each fraction is assigned a share of that alcohol — the split a typical pot-still run produces — and the share is converted back to a collected volume at the fraction's typical average strength:
Fraction volume = A × share ÷ average ABV- Foreshots — 2 % of the alcohol, collected at about 80 % ABV. Always discarded.
- Heads — 15 % of the alcohol, at about 72 % ABV.
- Hearts — 48 % of the alcohol, at about 62 % ABV. This is the keeper fraction.
- Tails — 35 % of the alcohol, at about 25 % ABV. The largest volume of the four, because the alcohol arrives diluted in a lot of water.
Example
A 25 L wash at 10 % ABV holds 2.5 L of pure alcohol. The model gives foreshots of 63 mL (the first 0–63 mL off the spout), heads of 521 mL (collect 63–583 mL), hearts of 1,935 mL (583–2,519 mL) and tails of 3,500 mL(2,519–6,019 mL) — about 6.02 L of distillate in total. To proof the hearts down to drinking strength afterwards, use the alcohol dilution calculator.
Accuracy & limitations
- This is an empirical planning estimate, not a measurement and not a recipe. The shares and average strengths are typical pot-still values; your still geometry, heat input and wash will shift every one of them.
- Real cuts are made by temperature, smell and taste, collecting in small jars. The ranges say roughly where to pay attention — never exactly where to cut. Fractions overlap and are blended by the distiller's judgment.
- Foreshots are always discarded, never drunk. No estimate on this page changes that.
- The model assigns all of the wash's alcohol to the four fractions; a real run leaves a little behind in the boiler, so expect slightly less distillate than shown.
- Accepted ranges: 1–200 L of wash, 1–40 % ABV. Distilling at home requires a licence or is prohibited in many places — check your local law; fermenting a wash and distilling it are regulated differently.
FAQ
Are these cut points exact?
No — and no calculator can make them exact. The volumes are an empirical planning estimate built from typical pot-still values: about 2 % of the alcohol in the foreshots, 15 % in the heads, 48 % in the hearts and 35 % in the tails, each at a typical average strength. Real transitions move with your still, your heating and your wash. Use the ranges to know roughly where a transition is coming, then make the actual cut by temperature, smell and taste, collecting in small jars so you can decide jar by jar.
What should I do with the foreshots?
Discard them — always, without exception. The foreshots are the first, most volatile part of the run: they smell of solvent and nail-polish remover and carry the highest share of methanol and other harsh compounds. They are never drunk, never blended back and never used to top up a spirit. Many distillers keep them clearly labelled as a cleaning solvent or firelighter where that is permitted; otherwise pour them away safely so nobody can mistake them for product.
Why collect in small jars instead of one big vessel?
Because the boundaries between fractions are blends, not walls. If everything runs into one vessel, the heads and tails contaminate the hearts and there is no way back. Collecting in 150–250 mL jars lets you line the run up in order, let the jars air overnight, then nose and taste along the row: the jars that smell clean and sweet become your hearts cut, and you can blend in a jar or two of late heads or early tails for character — or leave them out. The calculator's ranges simply tell you how many jars to have ready and roughly where the interesting decisions will happen.
Is it legal to distil at home?
In many countries and states, distilling alcohol at home requires a licence or is prohibited outright, even in small amounts and even for personal use — while fermenting the wash itself is often legal. The rules differ sharply by place and change over time. This calculator only plans the volumes of a run; check your local law before distilling anything, and see the sugar wash calculator for the fermentation side.