Distillation Cuts: Heads, Hearts & Tails
A spirit run does not come off the still as one uniform liquid. It arrives in fractions, in order, and each one smells and tastes different: the sharp foreshots first, then the solvent-edged heads, then the clean hearts you keep, then the heavy tails. Knowing roughly how much of each to expect — and making the actual cut by sense rather than by volume — is the difference between a drinkable spirit and a harsh one.
What the four fractions are
Everything starts from the pure alcohol in the wash. Each fraction takes a share of that alcohol, and the share converts back to a collected volume at the fraction's typical average strength. The figures below are the typical pot-still split the distillation cuts calculator plans from:
| Fraction | Share of alcohol | Typical strength | What to do |
|---|---|---|---|
| Foreshots | 2% | ~80% ABV | Discard — always |
| Heads | 15% | ~72% ABV | Set aside; blend a little back only if wanted |
| Hearts | 48% | ~62% ABV | The keeper fraction |
| Tails | 35% | ~25% ABV | Largest volume; mostly water by the end |
Tails are the largest volume of the four, because the alcohol arrives diluted in a lot of water. A real run also leaves a little alcohol behind in the boiler, so expect slightly less distillate than the model shows.
Worked example: a 25 L wash at 10% ABV
A 25 L wash at 10% ABV holds 2.5 L of pure alcohol. The model gives:
| Fraction | Volume | Running total |
|---|---|---|
| Foreshots | 63 mL | 0–63 mL |
| Heads | 521 mL | 63–583 mL |
| Hearts | 1,935 mL | 583–2,519 mL |
| Tails | 3,500 mL | 2,519–6,019 mL |
About 6.02 L of distillate in total. Plan the run from your own wash volume and strength with the distillation cuts calculator — it accepts 1–200 L of wash at 1–40% ABV — and set out enough small jars to cover the total before you light the burner.
Making the cut by sense, not by volume
The volumes above are a planning estimate, not a recipe. Your still geometry, heat input and wash shift every transition, so the real cuts are made by temperature, smell and taste:
- Collect in small, numbered jars (150–250 mL each) and swap jars as the running total passes the range boundaries.
- Let the jars air overnight, then nose and taste along the row in order. Heads smell of solvent and nail-polish remover; hearts smell clean and sweet; tails turn oily, with wet-cardboard and earthy notes.
- Blend your hearts cut from the clean jars. You can blend in a jar or two of late heads or early tails for character — or leave them out. The choice is the distiller's, and it is the whole point of collecting in jars: if everything ran into one vessel, the heads and tails would contaminate the hearts and there would be no way back.
Safety and legality
- Foreshots are always discarded, never drunk. They are the first, most volatile part of the run and carry the highest share of methanol and other harsh compounds. Never blend them back, never use them to top up a spirit. Many distillers keep them clearly labelled as a cleaning solvent or firelighter where that is permitted; otherwise pour them away safely so nobody can mistake them for product.
- Check your local law. Distilling alcohol at home requires a licence or is prohibited outright in many countries and states, even in small amounts and even for personal use — while fermenting the wash itself is often legal. The two are regulated differently.
After the cut, proof the hearts down to drinking strength with the alcohol dilution calculator, and measure the final strength at 20 °C with an alcoholmeter — see the temperature correction guide if the sample is warmer or colder.
FAQ
Are these cut points exact?
No — and no calculator can make them exact. The volumes are an empirical planning estimate built from typical pot-still values. Real transitions move with your still, your heating and your wash. Use the ranges to know roughly where a transition is coming, then make the actual cut by temperature, smell and taste, collecting in small jars so you can decide jar by jar.
What should I do with the foreshots?
Discard them — always, without exception. The foreshots are the first, most volatile part of the run: they smell of solvent and nail-polish remover and carry the highest share of methanol and other harsh compounds. They are never drunk, never blended back and never used to top up a spirit.
Why collect in small jars instead of one big vessel?
Because the boundaries between fractions are blends, not walls. If everything runs into one vessel, the heads and tails contaminate the hearts and there is no way back. Collecting in 150–250 mL jars lets you line the run up in order, let the jars air overnight, then nose and taste along the row and blend your hearts cut from the clean jars.
Is it legal to distil at home?
In many countries and states, distilling alcohol at home requires a licence or is prohibited outright, even in small amounts and even for personal use — while fermenting the wash itself is often legal. The rules differ sharply by place and change over time. Check your local law before distilling anything.
Try the calculator
Plan your run with the distillation cuts calculator: enter the wash volume and its ABV — measured with a hydrometer, or planned with the sugar wash calculator — and get the collection window for each cut.